Set a desired temperature (setpoint) for solar system to activate
Please note
Setting a water temperature setpoint for the solar system is only useful if the SOLAR CONTROL MODE is set to "HYBRID" or "ECO" mode. See "Solar Control Mode".
ALSO Note:
- The maximum temperature the Solar System can be set to is 104° F (40° C).
- The solar system will be set to off if incoming water temperatures are above 108° F (42° C). This assumes the heat pump is controlling the solar system and it was installed as recommended.
Example:
The solar system is set from 78° F to 80° F.
Enter "Shortcuts" menus, then proceed
A
PRESS MENU
BUTTON
/enter_level/enter_shortcuts-1.jpg)
B
USE ARROWS TO
"SHORTCUTS"
/enter_level/enter_shortcuts-2.jpg)
C
PRESS "ENTER"
/enter_level/enter_shortcuts-3.jpg)
1
USE ARROWS TO
SOLAR SETPOINT
/solar/set_solar_setpoint_temp -1.jpg)
2
ENTER TO EDIT
/solar/set_solar_setpoint_temp -2.jpg)
3
ARROWS TO CHANGE
/solar/set_solar_setpoint_temp -3.jpg)
4
ENTER TO SAVE
/solar/set_solar_setpoint_temp -4.jpg)
MENU TO EXIT, PRESS
& HOLD TO STATUS
/enter_level/exit_menus_heat.jpg)