Site Configuration Presets (Optional)

A list of site configurations (presets) can be used to easily configure equipment directly connected to the heat pump. Connected equipment, such as a circulation pump for example, can have all the necessary options automatically set to operate the device.

Note

The standard (from the factory) heat pump does not use groups or schedules. These can be created as needed depending on if a heat pump option has been utilized. See Product Manual Options for more information on available options.

NOTICE

Failure to heed the following may result in damage to equipment.

Any existing programs or settings will be cleared and replaced with the chosen preset option. If this is undesired, then press the button under "SKIP" to exit the menu and set up equipment manually.
After using a preset, values such as system RPMs should be checked to confirm they do not exceed system requirements. Damage to equipment due to excessive water flow, from setting RPMs too high, is not covered under factory warranties.

Note

After using a preset, any setting can be manually customized (or fine tuned) by the installer. Values, such as circulation pump RPMs, should be checked to confirm they do not exceed system requirements.

Also Note

If necessary, the system can be set to factory default if an incorrect preset has been used. See "Factory Reset".
If a third-party external controller was used prior to upgrading the system, a factory reset will be required to see all presets. See "Factory Reset".
If the PoolSync® external controller was used prior to upgrading the system, all applicable heat pump presets will be shown.

Navigate to the installation menus to access these preset configurations.

Enter "Installation" menus, then proceed

PRESS MENU

BUTTON

USE ARROWS TO

"SYSTEM"

PRESS "ENTER"

USE ARROWS TO

"ADVANCED"

PRESS "ENTER"

USE ARROWS TO

"INSTALLATION"

PRESS "ENTER"

Select the appropriate preset for the site conditions.

Preset Options: